Andreia Professional Builder Gel 3 In 1 - Medium Viscosity Soft White 44gr

Medium viscosity and low heat builder gel 3 in 1. Acid free. It’s self-levelling and works as a base, builder and top coat. Fluid texture and very high resistance. LED and UV curable. Compatible with other gel viscosities.

Preparation:
1. Clean hands with the Alcohol Power Spray.
2. Prepare the nails, remove natural shine, and clean with the All-in-One Prep + Clean.
3. Apply the Ultrabond Primer and allow to air-dry for 60 seconds.


Application:
1. Apply a thin layer of Builder Gel 3in1 Medium Viscosity to create a base. Seal the edge of the nail. Cure for 60 seconds in LED light or 120 seconds in UV light*.
2. Apply a moderate amount of Builder Gel 3in1 Medium Viscosity, in the centre of the nail to make the construction, and extend it, avoiding contact with the cuticle. Cure for 60 seconds in LED light or 120 seconds in UV light*.
3. Remove inhibition layer with All-in-One Prep + Clean.
4. Work the constructed nail with the Nail File or a nail drill.
5. Clean nail with the All-in-One Prep + Clean.

Finishing:
1. Apply a layer of Builder Gel 3in1 Medium Viscosity. Seal the edge of the nail. Cure for 60 seconds in LED light or 120 seconds in UV light*.
2. Remove sticky layer with the All-in-One Extra Glow.

* The cure time may vary depending on the equipment used.

URETHANE ACRYLATE, BISPHENOL A EPOXY DIMETHACRYLATE, ISOBORNYL METHACRYLATE, BIS(GLYCERYL DIMETHACRYLATE) PYROMELLITATE, TRIETHYLENE GLYCOL DIMETHACRYLATE, ETHYL TRIMETHYLBENZOYL PHENYLPHOSPHINATE, RICINUS COMMUNIS SEED OIL, BHT, P-HYDROXYANISOLE, CI 77891, CI 60725.

For professional use only, Avoid skin contact, Read directions for use carefully, Can cause an allergic reaction, Avoid contact with eyes, In case of contact with eyes, rinse immediately with plenty of water and seek medical advice, Keep out of reach of children.