Andreia Professional Hard Gel 2 In 1 - High Viscosity Peach 44gr

High viscosity and low heat builder gel 2 in 1. Acid free. Extremely resistant and self-levelling, it works as a base and builder. Thick texture, ideal for creating extensions in all formats, even the most extreme. LED and UV curable. Compatible with other gel viscosities.

Preparation:
1. Clean hands with the Alcohol Power Spray.
2. Prepare the nails, remove natural shine, and clean with the All-in-One Prep + Clean.
3. Apply the Uabond Primer and allow to air-dry for 60 seconds.

Application:
1. Apply a thin layer of Hard Gel 2in1 to create a base. Seal the edge of the nail. Cure for 60 seconds in LED light or 120 seconds in UV light*.
2. Apply a moderate amount of Hard Gel 2in1, in the centre of the nail to make the construction, and extend it, avoiding contact with the cuticle. Cure for 60 seconds in LED light or 120 seconds in UV light*.
3. Remove inhibition layer with All-in-One Prep + Clean.
4. Work the constructed nail with the Nail File or a nail drill.
5. Clean nail with the All-in-One Prep + Clean.

Finishing:
1. Apply a layer of All-in-One Top Coat. Seal the edge of the nail. Cure for 60 seconds in LED light or 120 seconds in UV light*.
2. Remove sticky layer with the All-in-One Extra Glow.

* The cure time may vary depending on the equipment used.

URETHANE ACRYLATE, BISPHENOL A EPOXY DIMETHACRYLATE, BIS(GLYCERYL DIMETHACRYLATE) PYROMELLITATE, TRIETHYLENE GLYCOL DIMETHACRYLATE, RICINUS COMMUNIS SEED OIL, ISOBORNYL METHACRYLATE, ETHYL TRIMETHYLBENZOYL PHENYLPHOSPHINATE, BHT, P-HYDROXYANISOLE, CI 77891, CI 77499, CI 15850, CI 77491.

For professional use only, Avoid skin contact, Read directions for use carefully, Can cause an allergic reaction, Avoid contact with eyes, In case of contact with eyes, rinse immediately with plenty of water and seek medical advice, Keep out of reach of children.